[Freifunk-Bonn] TP-Link WR 841 als Switch für Heimnetzwerk verwenden

[edgar.soldin at web.de]

comment inline below

On 04.09.2022 22:17, Thorsten wrote:
> Am 2022-09-04 20:58, schrieb edgar.soldin at web.de:
>> theoretisch isset simpel. lan interface aus dem freifunk client raus
>> und dafür mit wan brücken. an sich könntest Du das auch ohne
>> Anleitung.
>>
>> poste doch mal bitte die komplette `/etc/config/network` im original.
>> vlt. kann ich da adhoc was diktieren.
>
> Bitte sehr.
>
> config interface 'loopback'
>      option ifname 'lo'
>      option proto 'static'
>      option ipaddr '127.0.0.1'
>      option netmask '255.0.0.0'
>
> config globals 'globals'
>      option ula_prefix 'fd1f:ed18:886c::/48'
>
> config interface 'wan6'
>      option proto 'dhcpv6'
>      option ifname 'br-wan'
>      option ip6table '1'
>      option sourcefilter '0'
>      option peerdns '0'
>      option reqprefix 'no'
>
> config switch
>      option name 'switch0'
>      option reset '1'
>      option enable_vlan '1'
>
> config switch_vlan
>      option device 'switch0'
>      option vlan '1'
>      option ports '1 2 3 4 0t'
>
> config interface 'wan'
>      option igmp_snooping '1'
>      option multicast_querier '0'
>      option peerdns '0'
>      option auto '1'
>      option type 'bridge'
>      option proto 'dhcp'
>      list ifname 'eth0'
>      list ifname 'eth1'

das nicht original, original isset hier entweder eth0 oder eth1
setz doch bitte nochmal zurück und schick den ausgangszustand

> config rule6 'wan6_lookup'
>      option mark '0x01/0x01'
>      option lookup '1'
>
> config route6 'wan6_unreachable'
>      option type 'unreachable'
>      option table '1'
>      option target '::/0'
>      option metric '65535'
>      option gateway '::'
>      option interface 'loopback'
>
> config interface 'mesh_wan'
>      option vxlan '1'
>      option ifname 'br-wan'
>      option index '0'
>      option proto 'gluon_wired'
>      option disabled '1'
>      option transitive '1'
>
> config interface 'mesh_lan'
>      option igmp_snooping '0'
>      option ifname 'eth0.1'
>      option index '4'
>      option vxlan '1'
>      option proto 'gluon_wired'
>      option disabled '1'
>      option transitive '1'
>      option macaddr '96:a7:e1:bc:85:74'
>
> config interface 'mesh_vpn'
>      option ifname 'mesh-vpn'
>      option transitive '1'
>      option mtu '1398'
>      option macaddr '96:a7:e1:bc:85:77'
>      option fixed_mtu '1'
>      option proto 'gluon_mesh'
>
> config interface 'mesh_radio0'
>      option proto 'gluon_mesh'
>
> config interface 'client'
>      option igmp_snooping '1'
>      option type 'bridge'
>      option auto '1'
>      option ra_holdoff '30'
>      option multicast_querier '1'
>      option macaddr '30:b5:c2:ab:f2:2a'
>      option ipv6 '1'
>      option keep_ra_dnslifetime '1'
>      option sourcefilter '0'
>      option peerdns '1'
>      option robustness '9'
>      option reqprefix 'no'
>      option query_interval '2000'
>      option query_response_interval '500'
>      option proto 'dhcpv6'
>      list ifname 'local-port'
>      list ifname 'bat0'
>
> config device 'local_node_dev'
>      option type 'veth'
>      option name 'local-node'
>      option peer_name 'local-port'
>      option macaddr '16:42:ca:fe:be:ef'
>      option peer_macaddr '30:b5:c2:ab:f2:2a'
>
> config interface 'local_node'
>      option ifname 'local-node'
>      option ip6addr 'fdff::ff/128'
>      option ip6deprecated '1'
>      option proto 'static'
>
> config interface 'gluon_bat0'
>      option gw_mode 'client'
>      option proto 'gluon_bat0'
>
> config interface 'bat0'
>      option multicast_router '2'
>      option ifname 'bat0'
>      option auto '1'
>      option macaddr '30:b5:c2:ab:f2:2a'
>      option learning '1'
>      option proto 'none'
>
> config route6 'local_node_route6'
>      option target 'fdfe::/64'
>      option gateway '::'
>      option interface 'client'
>